The SF600 is a high speed "in System Programming" programmer to update the SPI Flash soldered on board (In Circuit Programming) or in the socket adaptor (Off line programming).

SF600 SPI Flash Programmer

The programmer is easily controlled by the computer DediProg Software through the USB bus offering friendly interface and powerful features to users. SF600 combines the advantages of SF100, SF200 with additional improvements:

  • High speed USB
  • Higher SPI performances
  • Support Dual and Quad IO serial flash mode
  • Isolation free: the on board Serial Flash can be programmed without isolation circuit

The programmer is easily controlled by the computer DediProg Software through the USB bus offering friendly interface and powerful features to users.

The SF600 USB software tool chain offers high flexibility and fit the different and highest requirements

Engineering Graphic human interface: for engineers and expert to access advanced features for development, repairing etc.

Production Graphic human interface: for operators in production to control multiple programmers and improve the throughput.

Command line interface: Customer software can control the multiple SF600 programmers (SF600 integration, Control SF600 with Production In Circuit Tester..)

Features :

  • USB High speed and high SPI performance
  • In circuit Programming: Program on board SPI Flash
  • Off line Programming: Program SPI Flash in the socket
  • Support Single, Dual and Quad IO serial communication (new serial Flash protocol)
  • Program two Serial Flash memories
  • Start button feature
  • Signal conflict protections
  • Multi-Programmers Capability through USB
  • Supports 1.8 Volt low voltage devices
  • Supports Windows 2003 and above
  • Supports both 32 bit or 64 bit OS

Hardware :

SF600 is designed with an ISP header, through an appropriate connector, users can connect the programmer and drive the SPI signals, supply the memory and control the controller or application status. DediProg also provides the SF600 ISP Cable which is used to connect the SF600 programmer to the 2X6 2.54mm ISP Pin Header on board.

Contents:

  • 1x USB cable
  • 1x SF600 Programmer
  • 1x ISP cable (Model name: ISP-600-CB1-G)
  • 1x SF600 Universal Adaptor (Model name: ADP-SF600-TO-SF100)
  • CDROM with Software, specifications and user manual

All DediProg tools, programmers, emulators and debuggers can be ordered at Eltan.

Related Documents:

SF600 Manual

SF600 Series Specification

SF Series device support list